Senseca FLEX-HD2K-IKK Flowmeter

FlowmeterFlow Meter / Monitor FLEX-HD2K● ● ● ● ● ● ● ●viscosity stabilized 4..20 mA or 0..10 V output signal 1 x programmable switch or frequency outputProgrammable switching value, full scale, or zero point via magnet clip Programming protection by removal of the clipPolished metal housing Rotatable electronic head for alignment of the 90° cable outletLED for switching value displayThe sensors work with a 16-bit processor, a 12-bit A/D and a 12-bit D/A converter. Linearisations and calibrations are carried outautomatically. The Flash memory guarantees the exchangeability of all programs.There is a choice between a switch with transistor output (push-pull) or a frequency output. The analog output 4..20 mA or0..10 V can be used at the same time. Many options are available for the switching outputs.variable ranges for the analog outputs variable hystereses Minimum or maximum switchInversion of the outputs Window function Delay after switching voltage onSwitching delays (On, Off)Metering range Pressure loss Qmax.Tolerance Media temperature Media temperatureoils see section "Wiring" 18..30 V DC <1 W4..20 mA / load 500 W max.or 0..10 V / load min. 1 kW Switching output transistor output "push-pull", (resistant toshort circuits, and reversal polarity protected) lout = 100 mA max.Display (only with yellow LED (On = OK / Off = Alarm) switching output) IngressIP 67 protection Electrical for round plug connector M12x1, 4-pole connectionMaterials Brass construction:Stainless steel medium-contact CW614N nickelled, construction: 1.4571, CW614N, 1.4310,1.4404, 1.4310, hard hard ferrite, NBR ferrite PTFE-coated, FKM Non-mediumCW614N, PPScontact materials Weight see table "Dimensions and weights" InstallationStandard: horizontal inwards flow; other location installation positions are possible; theinstallation position affects the metering and switching range.Value x = Begin of the specified range = not specified range Current outputmAVoltage output V20104 0x100 % Flow00x100 % FlowFrequency outputTechnical data Sensor Nominal width Process connection-20..+70 °CSignal output curvesCharacteristics● ● ● ● ● ● ●Ambient temperature Media Wiring Supply voltage Power consumption Analog outputV analog hall sensorDN 8..25 female thread G 1/4..G 1 (further process connections available onrequest) 0,5..60 l/min for details see 1,1..3,5 bar bei Qmax.table "Ranges" to 80 l/min ±3 % of full scale valuePN 200 bar optionally PN 500 barfmax00x100 % Flowfmax selectable in the range of up to 2000 Hz Other characters on request.-20..+85 °C optionally -20..+150 °Cpi-ho_fki-flex-hd2k_e V1.01-001